Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL FEBREZE
FAN OPERATION
If you would like to use the scent distribution feature on your fan, you need to install and activate
a Febreze
Set&Refresh
®
Your Honeywell with Febreze Freshness™ Cool & Refresh Fan package contains one Febreze
Set&Refresh
Advanced Odor Eliminator scent cartridge at the time of purchase.
®
1 - Turn Fan Off
Make sure your fan is
turned OFF.
4 - Position Cartridge
Hold the Set&Refresh
scent cartridge so that the
curved side is facing
upward.
SET&REFRESH
®
scent cartridge.
®
2 - Remove Cartridge
Remove the Set&Refresh
scent cartridge from the
enclosed packaging. Do not
peel or cut the cartridge
5 - Insert Cartridge
Line the cartridge up with
®
the slot inside the Scent
Cartridge Compartment.
Slide the scent cartridge into
the slot until it is firmly in
place.
SCENT CARTRIDGE
®
®
- 4 -
3 - Open Cartridge Door
Open the door to the Scent
Cartridge Compartment
located in the center of the
fan control panel.
6 - Close Cartridge Door
Close the door to the Scent
Cartridge Compartment.
®
Publicidad
