Domo DO7275S Manual De Instrucciones página 36

DO7275S
INSTRUCTIONS FOR USE
Before using the appliance, unwind the power cord. Put the plug into the socket. A
yellow marking on the cord indicates the ideal length for unwinding the cord. On
the power cord is also a red marking, never unwind the power cord further than this
marking.
1. Press the on/off button to turn on the unit.
2. Turn the speed control knob to set the desired suction power.
3. On the handle that is attached to the tubes, there is a small slide button for extra
suction control.
4. Switch off the vacuum cleaner with the on/off button.
5. To wind the cord, remove the plug from the socket en hold it while pressing the
rewind button with the other hand. You need to hold the plug while rewinding to
prevent damage during rewinding.
CLEANING DUST CONTAINER AND FILTERS
Before cleaning your vacuum cleaner or accessories, always turn off the appliance and
remove the plug from the socket.
Dust container
1. Take hold of the handle, press down the silver coloured button on top of the
appliance and gently pull up the dust container. The
dust container slides out of the appliance.
2. On the side of the dust container the opening system
is located.
3. Push the lid of the dust container upwards, while
holding down the bottom of the dust container. Hold
the dust container over a dustbin and flip it over, so
that the dirt falls out.
HEPA filter (A)
You can now clean the HEPA filter inside the dust
container. Remove the HEPA filter from the dust
container by pulling the tab and clean the filter
under running water. Let the filter dry in open air
before replacing it back into the vacuum cleaner.
Air outlet filter (B)
This filter will clean the air before leaving your
vacuum cleaner. The air outlet filter is situated
at the back of the vacuu m cleaner. Remove the
grill and take out the filter. Clean under running water, let it dry thoroughly before
replacing it into the vacuum cleaner.
36
B
A