Garland HUNTER 755 SG Manual De Instrucciones página 47

7.3. CUTTING WITH THE LAWNMOWER
Place the mower in a corner of the lawn area to be
cut and set the desired cutting height.
Check that the bag is properly installed; make sure
that the blade is not in contact with any object, and
start the mower.
Walk on the grass to the rhythm of the mower.
Do not tilt the machine with the engine running
except in the case that you have to start cutting tall
grass, which is the only case in which you may raise
the front wheels slightly to facilitate entry of the
mower to the work area.
Note: If the grass is very high it will be difficult for
you to start the engine. If the grass is very high, you
should slightly raise the lawnmower's front wheels,
forcibly pushing down with the handle, and start
your lawnmower in this position. Once the engine
has acquired the normal engine speed slowly lower
the mower wheels while the machine starts to cut.
Alternatively, if next to the lawn area there is a flat
surface free of objects and without grass (Earth,
screed, concrete), start the lawnmower in the clear
area and entering the grass area by slightly lifting the
front wheels of the lawnmower.
If the engine's rotation speed goes into excess or
it stops, it means that the grass is too high for the
lawnmower's cutting capacity and forcing this can be
harmful to the machine. In this case, make a first cut
at the machine's maximum height and then a second
cut at the desired height.
7.4. EMPTYING THE BAG
Empty the lawnmower's bag as soon as you notice
it is full. You will notice that the bag is full because
the mower will stop picking up the cut grass as well,
leaving many remains on the ground.
Whenever you are going to empty the bag, turn off
the engine and check that the blade has stopped
before removing the bag.
1. Lift the lid from the rear exit.
2. Lift the sack.
3. Remove the bag back.
4. Empty the bag.
5. Lift the lid from the rear exit.
6. Place the bag by hooking the protrusions on the
chassis of the bag to the of the bag rear cover
axle.
7.5. RECOMENDATIONS
Always cut the grass when it is dry. Avoid mowing
the lawn when it is wet after having watered or after
having rained.
Cut less than 2 cm of grass at a time. If your lawn is
very high, it is advisable to make successive passes
with the 2 cm cutting height every time. So no it will
force both machine.
Cut your lawn often, at least once a week in spring
and summer.
Do not always make the same route when mowing. It
is best to change your route to avoid the grass being
cut in the same direction.
47/184
English