Descargar Imprimir esta página

Candy BI BM 193 NF Manual Del Usuario página 29

Publicidad

appliance should sit flush against the
cabinet edge (if it does not, ensure the
base is aligned as per Fig. 9 and that the
metal trim in Fig. 10 is not damaged).
Secure the top of the appliance to the
top of the cabinet through the metal trim
screw holes marked 'T' in fig 10.
Remove the white spacers from the base
plates and secure the plates to the
cabinet base using four of the supplied
screws. Replace the spacers.
Mounting the fascia
doors
• Ensure that there is a gap of 3 to 4mm
between the non-hinged side and the
cabinet wall.
• Locate the slider in the bracket and fix
the slider to the fascia door 20 to 22mm
from the edge of the fascia as shown in
figure 11, ensuring that the slider is
positioned centrally and horizontally
within the bracket. Tighten securely by
hand.
• Fill the gap on the non-hinged side with
the gasket/seal strip provided, as shown
in Fig. 12.
• The finished look for the door sliders
should be similar to those shown in Fig.
14, which shows 2 sliders in place.
• Ensure the appliance doors open, close
and seal properly.
Once complete, and if you are happy
with the fit of the appliance in the
cabinet, bend and snap the parts of the
white spacers marked 'S' as shown by the
dotted outline in fig. 13. Leave the rest of
the spacer cover in place over the metal
plates.
Important: After completing the
installation, check that the appliance is
29

Publicidad

loading