DO7098S
•
Do not operate the appliance with wet hands.
•
Unwrap the cord completely to prevent overheating of the cord.
•
Do not let the power supply cord touch hot surfaces.
•
Only fill the water reservoir with no other liquid than water.
•
Make sure the appliance is correctly assembled, then plug the cord in the wall
outlet. To disconnect, turn controls to "OFF" or "0" position, then remove the plug
from the wall. Never pull the cord or appliance to remove the plug from the socket.
•
Make sure the appliance has cooled down before opening the boiler for cleaning.
Make sure the bolt of the boiler is correctly and well fixed onto the appliance after
maintenance.
•
Failure to maintain this appliance in a clean condition could adversely affect the
life of the appliance and possibly result in a hazardous situation.
•
Any injury or damage caused by failure to comply with these rules are at your own
risk. Neither the manufacturer, importer, or the supplier may be held liable.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
PARTS
1. Filling cap
2. Trigger for removing the
water tank
3. Handle
4. Water tank
5. Steam release button
6. Soleplate
7. Temperature dial
8. Temperature indicator
9. Iron
10. Thermal insulation pads
11. Steam generator
12. Control panel
13. Cord clamp
14. Descaling cartridge
Trigger
Grab the water tank by the handle and pull the trigger. You can now remove the water
tank from the generator.
Filling cap
Open the filling cap and use the opening to fill the water tank.
On/off button (A)
Plug in the appliance and press the on/off button. The on/off indicator (B) will light
3
1
2
4
14
46
5
6
11
13
7
8
9
10
12