Makita DJV181 Manual De Instrucciones página 8

Disabling or enabling the soft
no-load rotation function
To disable or enable the soft no-load rotation function,
follow the steps below.
1. Make sure that the tool is turned off.
2. Set the speed adjusting dial to "1".
3.
Press the lock switch to turn on the tool.
4.
Turn the speed adjusting dial to "6", and then set it back to "1".
The lamp blinks twice when the soft no-load rotation
function is disabled or enabled. To enable or disable this
function again, perform the same procedure again.
NOTE: If the soft no-load rotation function is disabled,
the lamp blinks twice when the tool is turned on.
NOTE: You can also disable or enable the soft
no-load rotation function by changing the speed
adjusting dial to "6" - "1" - "6".
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing saw blade
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
• Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
• Tighten the saw blade securely. Failure to do so
may cause a serious injury.
• When you remove the saw blade, be careful not
to hurt your fingers with the top of the blade or
the tips of workpiece.
► 1 . Fixed position 2. Released position
Before installing the blade, make sure that the blade
holder is in the released position.
To install the blade, insert the blade (teeth facing for-
ward) into the blade holder until it latches. The blade
holder moves to the fixed position by itself and the
blade is locked. Pull the blade lightly to make sure that
the blade does not fall off during operation.
CAUTION:
• Do not open the tool opener excessively, or it
may cause tool damage.
1
► 1 . Jig saw blade
To remove the blade, push the tool opener forward as
far as it will go. This allows the blade to be released.
NOTE: In case that it is difficult to remove the jig saw
blade:
Turn the cutting action changing lever to the position
"III" and move the jig saw blade holder to the bottom
before pushing the blade clamp lever to the released
position. To move the jig saw blade holder to the
bottom, return the blade clamp lever fully to the fixed
position once and slightly switch on the tool several
times.
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
1
1
► 1 . Base 2. Hex wrench
When not in use, store the hex wrench as shown in the
2 figure to keep it from being lost.
8 ENGLISH
2