Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
HOOK UP CONNECTIONS
2. CONNECT TO POWER
This machine runs on a fully-charged 12-Volt battery
Connect red lead (+) to battery's positive terminal
Connect black lead (-) to chassis ground
Do not connect to battery charger or jumper box
Max voltage 12V DC
POWER INDICATOR:
Green Light: Machine has adequate power
No Light: No Power, See Troubleshooting Section
3. CONNECT TO AIR SUPPLY
Connect Air Input Hose to a compressed air supply
If necessary, replace Air Fitting to match your air supply
Max inlet pressure 150 PSI
6
MDSMOKELITE
1. FILL / ADD VAPOR PRODUCING FLUID
Remove Fluid Fill Dipstick. Pour Vapor Producing Fluid
into Fluid Fill Port until fluid level is near top of the fill
line on the Dipstick. Replace Fluid Fill Dipstick
Do not overfill
First time fill requires approx. 2 oz (60 ml)
Check fluid level every 50-100 tests
Never use dyes, solvents or other contaminants
intake or exhaust systems beca use they may
coat and/or harm critical sensors, catalysts
Fill Fluid to Maximum Fill Line on Dipstick
Publicidad
