Publicidad
Idiomas disponibles
Idiomas disponibles
Note
When carrying, the lens hood can be attached in the
0
reverse direction.
1
Remove the lens hood.
2
Align mark B (
on the tip of the lens.
3
Attach the lens hood by rotating it in the direction of
the arrow until it clicks.
It is recommended to remove the lens hood during
0
flash photography as the lens hood can block the light
from the flash.
To prevent dropping of the lens, you should never carry
0
the lens by just holding the lens hood.
∫ Notes on filter use
It is possible to attach the lens cap or the lens hood
0
with the filter already attached.
There may be some vignetting in recorded images if
0
multiple filters are attached simultaneously.
It is not possible to attach any items other than filters
0
such as a conversion lens or adaptor to the front of the
lens and use it in combination with this lens.
Lens damage may result if such items are attached.
22
DVQX1834
(ENG)
) on the lens hood with the mark
Switching AF/MF
Switch AF/MF by sliding the
focus ring A forwards or
backwards (focus clutch
mechanism).
When the digital camera is
0
set to MF, the operation will
be MF irrespective of the
position of the focus ring.
Check the length indication
0
B when using MF. Use it as a
guide for focusing.
AF
MF
1
1.2
1.5
2.5
5
feet
0.28 0.33
0.4
0.5
0.7
1.5
m
Publicidad
