Zibro Kamin R 170 C Instrucciones De Uso página 51

1 1 0 0
1 1 1 1 b b
1 1 3 3
1 1 5 5
1 1 6 6 b b
1 1 7 7
Place the new wick in the wick holder and press the
10
1 1 1 1 a a
wick pins firmly into the holes in the wick holder.
11 Put the wick holder (with wick) back into position by
pushing the two large pins on the outside of the wick
holder into the rebate in the wick mechanism. Turn the
wick holder clockwise until it is firmly in place.
1 1 2 2
Put the wick holder chassis back into position.
12
Screw opposite wing nuts in succession until they are
13
hand tight.
1 1 4 4
Check that the wick mechanism works by sliding the
14
lowest slide all the way down and pushing on the OFF-
button.
1 1 6 6 a a
Check that the tip-over-mechanism works by pushing
15
the lowest slide all the way down and tilting the small
piece of lead.
Put the cabinet back into position and tighten the
16
cabinet screws. Now put the combustion chamber back
1 1 6 6 c c
into position. Check that it is level by sliding it slightly
to the left and the right by its handle. Close the grill.
Put the filled removable tank back into position.
17
1 1 8 8 Put the batteries into the battery holder (ensure that
18
the positive and negative poles match the + and –
marks indicated on the battery housing). Wait 30
minutes after placing the removable tank and batteries
before using the heater.
4
49