Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION - RECIRCULATING
STEP 2: INSTALL HOOD MOUNTING
SCREWS
The mounting screws must enter the horizontal
support or wall studs.
With the template taped in place, use a punch to
mark mounting bracket screw locations.
in the lower bracket. If the bottom 2 pilot holes
install metal wall fastener anchors (provided).
Remove the template.
gap between the screw head and the wall. This
will allow the keyhole slot on the hood frame to
engage the screw head.
WALL VENT IS 27-3/4" MIN.
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
ABOVE THE INSTALLATION
HEIGHT
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
Horizontal Line
IMPORTANT: Use the mounting screws provided.
DO NOT USE DRYWALL SCREWS.
• Check to be sure the mounting screws are
horizontally level.
49-7000197 Rev. 0
Installation Instructions
10-1/8"
REAR WALL
MOUNTING TEMPLATE
C L
ALIGN BOTTOM EDGE
WITH PENCIL LINE
INDICATING BOTTOM
OF THE HOOD
12-1/2"
Installation Height
31-14772 Printed in Mexico
12-08 JR
(Cont.)
STEP 3: INSTALL DUCT BRACKET
AND DEFLECTOR
The duct bracket should be installed against the
where the ceiling meets the wall should be level
for the bracket and duct cover to fit flush. This
bracket will hold the duct cover in place at the top.
Secure the bracket to the wall:
Align the diamond centerline cutout on the
bracket to the penciled centerline on the wall.
Mark 2 screw hole locations in the wall.
If pilot holes do not enter wood studs, enlarge
anchors (provided).
If mounting directly to a masonry wall, obtain
appropriate #10 masonry screw anchors.
Drill and install per the fastener supplier's
instructions.
Drive screws, by hand, into the fasteners to
allow anchors to expand. Remove the screws.
Secure the bracket to the wall with wood screws
Centerline cutout
Assemble the air deflector accessory to the
duct cover bracket with the 4 assembly screws
provided. DO NOT tighten screws. This is a
temporary installation.
19
Publicidad
