Adjusting The Mowing Height - Makita HML01 Manual De Instrucciones

Adjusting the mowing height

WARNING:
Never put your hand or leg under the mower unit
•
when adjusting the mowing height.
Always make sure that the lever fits in the groove
•
properly before operation.
The mowing height can be adjusted in the range of
between 20 mm - 75 mm (0.8" - 3.0").
1. Remove the lock key.
012303
2. Pull the mowing height adjusting lever toward
yourself and move it to your desired mowing
height.
Make sure that the protrusion on the mowing
height adjusting lever fits in the groove in the
mower.
NOTE:
The mowing height figures should be used just as
•
a guideline, as the state of the lawn or ground may
cause lawn height to be slightly different to the set
height figure.
Try a test mowing of grass in a less conspicuous
•
place to get your desired height.
Battery protection system
Lithium-ion batteries are equipped with a protection
system. This system automatically cuts off power to the
tool to extend battery life.
The tool will automatically stop during operation if the
tool and/or battery are placed under one of the following
conditions:
Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this situation, release the trigger switch on
the tool and stop the application that caused
the tool to become overloaded. Then pull the
trigger switch again to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before pulling the trigger switch again.
Low battery voltage:
•
The remaining battery capacity is too low and
the tool will not operate. In this situation,
1. Mowing height
adjusting lever
1
remove and recharge the battery.
Battery remaining capacity indicator (only for
models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light for
approx. three seconds.
Indicator lamps
Lighted Off
E
011713
When only the lowermost indicator lamp (next to
•
the "E") blinks, or when none of the indicator lamps
light, the battery capacity has run out, so the tool
does not operate. In these cases, charge the
battery or replace the empty battery with a fully
charged one.
When two or more indicator lamps do not light
•
even after charging is complete, the battery has
reached the end of its service life.
When the upper two and lower two indicator lamps
•
light alternately,
malfunctioned.
authorized service center.
NOTE:
The indicated capacity may be lower than the
•
actual level during use or immediately after using
the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
6
1. Indicator lamps
2. CHECK button
Remaining capacity
Blinking
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
the battery
Contact your local
may have
Makita