Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
•
Trying to mow much grass at a time may not
allow the motor to start due to the overload. At
this time, change the mowing height to higher
level to restart.
•
The mower does not start without pressing the
switch button even if the switch lever is pulled.
This mower is equipped with the interlock switch and
handle switch. If you notice anything unusual with either
of these switches, stop operation immediately and have
them checked by your nearest Makita Authorized or
Factory Service Center.
1.
Install the battery cartridges. Insert the lock key
into the interlock switch and then close the battery
cover.
1
► 1. Battery cartridge 2. Lock key
2.
Press the switch button.
3.
Pull the switch lever toward you while pressing the
switch button.
1
► 1. Switch button 2. Switch lever
4.
Release the switch button as soon as the motor
starts running. The mower will continue to run until
you release the switch lever.
5.
Release the switch lever to stop the motor.
6.
When not in use, remove the lock key. Store the
lock key in a safe place out of reach of children.
2
► 1. Mowing height adjusting lever 2. Pins
The mowing height can be adjusted in the range of
between 25 mm - 75 mm (1.0" - 3.0").
1.
2.
2
7 ENGLISH
Adjusting the mowing height
WARNING:
•
Never put your hand or leg under the mower unit
when adjusting the mowing height.
•
Always make sure that the lever fits in the
groove properly before operation.
Remove the lock key.
Pull the mowing height adjusting lever toward A
side. Move it to your desired mowing height level.
Make sure that the pins on the mowing height
adjusting lever fit in the holes and the lever returns
to B side.
NOTE:
•
The mowing height figures should be used
just as a guideline, as the state of the lawn or
ground may cause lawn height to be slightly
different to the set height figure.
•
Try a test mowing of grass in a less conspicuous
place to get your desired height.
•
It is easier to move the mowing height adjusting
lever with holding the tool firmly.
2
B
A
1
Publicidad
Tabla de contenido
