Descargar Imprimir esta página

Hilti TE 70-ATC/AVR Manual De Instrucciones página 16

Ocultar thumbs Ver también para TE 70-ATC/AVR:

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Press the release button and pull the keyed, detachable electric plug
connector out of the socket.
3. Pull the supply cord connector out of the power tool.
5.1.3 Fitting the side handle
CAUTION
Risk of injury Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove in the product.
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the tool holder from the front
and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.4 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
5.1.5 Control switch lock
When chiseling, the control switch can be locked in the "on" position.
▶ Press the control switch lock.
5.1.6 Inserting the tool
The use of unsuitable grease can cause damage to the product. Use
only genuine Hilti grease.
1. Lightly grease the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in
damage to the product.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶ The product is ready for use.
5.1.7 Removing the accessory tool
▶ Pull the tool lock back as far as it will go and remove the accessory tool.
Use only genuine Hilti grease. The use of unsuitable grease can
cause damage to the product.
10
English
2
4
5
3
2244432
*2244432*

Publicidad

loading