Installation Without Base - Joie i-Gemm signature Manual De Instrucciones

Detaching Hood and Seat Pad
see images -
29 31
To detach the hood, simultaneously
press the button in the hood mount
and pull the hood bow out.
To detach the seat pad, you should
refer to the following steps:
1. You must remove the insert first.
To do this simply unlock the
buckle, then unclip the snaps on
both sides of the insert and pull out
away from the seat.
2. The shoulder harness cover or
crotch harness cover can be
removed from the webbing.
3. Detach the elastic bands on the
back of head support to remove
the head support soft goods.
4. Pull out the fastening pieces
underneath the edge of the seat.
5. Detach the seat pad from around
the adjustment button as shown in
31
To re-assemble the soft goods,
reverse the aforementioned steps.
19
29
29
30
30
31

Installation without base

see images -
32 39
!
DO NOT install this infant carrier
module on vehicle seats with Lap
Belts.
32
!
This infant carrier module is
suitable for vehicle seats with a
3-point Retractor Safety Belt only.
33
1. Place the infant carrier module
onto the vehicle seat where you
wish to put it. Pull the vehicle
safety belt out and lock it into the
vehicle buckle, sliding the vehicle
lap belt into the side guides of the
infant carrier module.
34
!
The infant carrier module can not
be used if the vehicle safety belt
buckle (female buckle end) is too
long to anchor the infant carrier
-1
module securely.
34
32
33
34
!
!
1
20