Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
NOZZLE MAINTENANCE
SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, clear them from the
brushroll.
CLEANING THE SOFT ROLLER
Slide the Soft Roller access button forward to
release the Soft Roller.
CORD MAINTENANCE
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut off power to
the vacuum and remove the cord from the
brushroll or nozzle.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed. Use only
water, and allow it to air-dry completely for at
least 24 hours. Reinsert the Soft Roller in the
front of the nozzle until it clicks into place.
1.
DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2.
DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3.
DO NOT close the door on the cord.
4.
DO NOT pull the cord around sharp
corners.
5.
DO NOT leave the cord near heated
surfaces.
CHECKING FOR BLOCKAGES
HOSE BLOCKAGE
Detach hose from vacuum pod, and
check hose and opening on back of
pod for blockages.
POD BLOCKAGE
Detach wand from floor nozzle,
tilt nozzle neck back, and check
opening for blockages.
NOZZLE HOSE BLOCKAGE
To access the nozzle hose, open the locks
on the bottom of the nozzle. With a coin,
turn the locks counterclockwise, then lift
the cover and clear any blockages.
WAND BLOCKAGE
Detach wand from floor nozzle and handle,
and check both ends for blockages.
HANDLE/HOSE BLOCKAGE
Detach handle from wand and hose
from the vacuum pod, and check
openings for blockages.
s h a r kc l e a n . c o m
Publicidad
