Descargar Imprimir esta página

Whirlpool WHES40 Manual De Instalación Y Operación página 7

Ocultar thumbs Ver también para WHES40:

Publicidad

Idiomas disponibles

Idiomas disponibles

VALVE DRAIN REQUIREMENTS
Using the flexible drain hose (included), measure and
cut to the length needed. Flexible drain hose is not
allowed in all localities (check your plumbing codes). If
local codes do not allow the use of a flexible drain
hose, a rigid valve drain run must be used. Purchase a
compression fitting (1/4 NPT x 1/2 in. minimum tube)
and 1/2" tubing from your local hardware store. Plumb
a rigid drain as needed (See Figure 6).
NOTE: Make the valve drain line as short and direct
as possible.
INLET / OUTLET PLUMBING OPTIONS
Always install either a single bypass valve (provided),
as shown in Figure 7, or, if desired, parts for a 3 valve
bypass system (not included) can be purchased and
assembled, as shown in Figure 8. Bypass valves allow
you to turn off the water to the softener for maintenance
if needed, but still have water in house pipes.
Use:
= Copper pipe
= Threaded pipe
= PEX (Crosslinked Polyethylene) pipe
= CPVC plastic pipe
= Other pipe approved for use with potable water
IMPORTANT: Do not solder with plumbing attached to
the single bypass valve. Soldering heat
will damage the plastic valve.
Installation Requirements
1/4" NPT
Thread
1/4 NPT
Clip
Threads
Cut barbs from drain fit-
ting (pull clip to remove
fitting from valve)
SINGLE BYPASS VALVE
3 VALVE BYPASS
Outlet
Valve
F
rom Water
Softener
7
Barbs for 3/8"
I.D. Tubing
Hose Clamp
Drain Hose
Compression Fitting.
1/4 NPT x 1/2" O.D.
Tube (not included)
Barbs
1/2" Outside Dia.
Copper Tube
(not included)
Pull out for "Service"
(Soft water)
Push in for
"Bypass"
Bypass
Valve
Inlet
Valve
T
o Water
Softener
FIG. 5
FIG. 6
FIG. 7
FIG. 8

Publicidad

loading

Este manual también es adecuado para:

Whes44L40pL44p