Descargar Imprimir esta página

BH FITNESS Pioneer R3 Instrucciones De Montaje Y Utilización página 19

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
around 70 calories per hour to keep our
vital functions active.
Before starting any exercise program,
bearing in mind that exercise programs
vary depending on age and physical
condition, it is advisable to consult your
doctor given that you will achieve better
results based on his/her advice or
suggestions. Regardless of whether your
goal is to become fitter, control your
weight or for physiotherapy, always
remember that your exercise should be
gradual, planned, varied and not too
demanding. We recommend that you
should exercise 3 to 5 times per week.
Before beginning a session it is
important to do a warm-up for 2-3
minutes at low speed. This will help
protect your muscles and prepare your
cardiorespiratory system.
The next stage will last 15-20 minutes
at a pulse rate of between 65 to 75%,
or between 75 to 85% for those already
accustomed to exercise.
At a later stage, once we have become
fitter, we can divide this time between
both levels but always remembering
that the pulse rate must not exceed
85% (aerobic area) and never reach
the maximum heart rate limit that
corresponds to our age.
We you have finished, it is important to
relax the muscles. This can be done by
walking at a low speed for 2-3 minutes
until the heart rate drops below the 65%
line.
This will prevent muscle pain, especially
after an intense session. It is also
advisable to finish the program with
some relaxation exercises on the floor.
FINAL NOTE
We hope that you enjoy your unit. You
will soon notice the benefits of your
controlled exercise program, you will
feel better, have more energy and
suffer less stress.
INSPECTION & MAINTENANCE.-
Switch the unit off and unplug the
mains cable.
Use a damp cloth or towel to clean the
dust off the treadmill, especially the
side bars and the electronic console.
Do not use solvents.
Use a vacuum cleaner to carefully
vacuum around the visible components
(belt, structure, etc.). You can also
vacuum the underside of the unit by
resting it on one of its sides. Similarly,
you can vacuum the inside of the motor
housing by removing the cover that
protects the motor (be careful with the
wires).
ATTENTION:
Periodically check that all of the
fastening
tightened and connected correctly.
Check and tighten all the parts on
your unit every three months.
Use of this machine with worn parts,
e.g. the drive belt, running belt or
rollers, may cause the user injury.
When in doubt about any parts on the
machine, do not hesitate to get in touch
with the Technical Assistance Service
by phoning customer services (see last
page in manual).
We recommend that your use original
spare parts to replace any worn
components. The use of other spare
parts may cause injuries or affect the
performance of the machine.
THE MANUFACTURER RESERVES
THE
RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE.
19
elements
are
TO
MODIFY
OF
WITHOUT
duly
THE
ITS
PRIOR

Publicidad

loading

Este manual también es adecuado para:

G6487b