Makita BTW251 Manual De Instrucciones página 6

Align the hole in the side of the socket with the detent pin
on the anvil and push it onto the anvil of the tool until it
locks into place. Tap it lightly if required.
To remove the socket, simply pull it off.
Hook
3
007521
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you.
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
007461
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
1. Hook
2. Screw
3. Groove
2
1
Standard bolt
N m
(ft lbs)
160
(116)
140
(101)
120
(87)
M14(9/16")
100
(72)
80
(58)
M12(1/2")
60
(43)
40
(29)
20
(14)
0
1.0
0 0.5
Fastening time (S)
007538
High tensile bolt
N m
(ft lbs)
200(145)
180(130)
160(116)
140(101)
120(87)
100(72)
80(58)
60(43)
40(29)
20(14)
0
1.0
Fastening time (S)
007537
NOTE:
Hold the tool pointed straight at the bolt or nut.
•
Excessive fastening torque may damage the
•
bolt/nut or socket. Before starting your job, always
perform a test operation to determine the proper
fastening time for your bolt or nut.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery
cartridge.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Socket
6
M16(5/8")
M16(5/8")
M14(9/16")
M12(1/2")
2.0
1.5
M14(9/16")
M14
(9/16")
M12(1/2")
M12
M10(3/8")
(1/2")
M10
(3/8")
2.0 3.0