Publicidad
Idiomas disponibles
Idiomas disponibles
5. Enclosure Configuration
5.2 Reversing the Enclosure Door
In order to accommodate various rack configurations, the enclosure door can be reversed. The direction in which the door opens is controlled by four
L-shaped levers on the inside of the enclosure.
To access these levers, you must first
1
remove the side panels following the
procedures outlined in section 5.1.
2
The levers (both top and bottom) on the side
from which the door opens must be
"DISENGAGED," while the levers (both top
and bottom) on the opposite side, the side
from which the door swings, must be
"ENGAGED."
3
Disengage the levers. Levers are
"DISENGAGED" when the short side of the
"L" lever is removed from its bracket cradle.
To remove short side of "L" lever from the
bracket cradle, push away from the bracket
cradle (either up or down) and rotate (either
towards or away from the door) so that the
short side of the "L" exits the cradle.
Remove the door. A metal bushing is located
4
on the bottom lip of the frame, on the side
from which the door was swinging.
5
Move the bushing from the side on which
the door was swinging to the opposite side
of the frame and line it up with the hole.
Line up the door on the opposite side and
6
engage the levers. Levers are "ENGAGED"
when the short side of the "L" rests in the
bracket cradle. To "ENGAGE", push lever to
compress the spring and rotate into the
bracket cradle. When engaging the bottom
lever, make sure it goes through the bushing.
7
Make sure that both top and bottom levers
on the side from which you want the door to
open are "DISENGAGED" and that both levers
on the side from which you want the door to
swing are "ENGAGED." Otherwise, door may
not function properly and damage may result.
5.3 Reversing the Enclosure
In order to accommodate various rack configurations, the entire enclosure can be reversed.
1
Remove side panels by following the procedure in section 5.1.
Remove front door by placing all four "L" levers in "DISENGAGED" positions and pulling it away from the enclosure.
2
Remove the metal bushing described in section 5.2.
3
Flip the enclosure.
4
Replace the metal bushing as explained in section 5.2.
5
6
Reattach front door and side panels.
2
( continued )
4
6
ENGAGED
5
DISENGAGED
6
2
3
DISENGAGED
6
ENGAGED
Publicidad
