Publicidad
Idiomas disponibles
Idiomas disponibles
7. Equipment Installation
7.2 Alternate Mounting: Tapped Hole Mounting Rail
Warning: Do not attempt to adjust rails while equipment is installed in the enclosure. Do not attempt to use rails without screws installed.
(2 per rail.)
The mounting rails are pre-installed for securing equipment using the square hole side of the mounting rail. To switch to the tapped hole side of the
mounting rail, follow the steps below:
1
Each rail is connected to the enclosure with 2 screws: 1 in the upper corner and another in the
lower corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to the
enclosure.
Switch the rail locations. Ensure the tapped hole side of each rail is facing the front door.
2
3
Reattach the mounting rails.
Use the included silver mounting screws to secure your equipment to the rack rail. Place the
4
cup washers between the screws and the equipment mounting brackets.
Note: Your equipment may also include mounting hardware. Read the mounting instructions that came with your equipment before installing your equipment.
(continued)
9
TOP RAIL
BOTTOM RAIL
1
2
TOP RAIL
BOTTOM RAIL
3
2
4
Publicidad
