Publicidad
Idiomas disponibles
Idiomas disponibles
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ....................volts
Hz ..................hertz
min ................minutes
or DC ....direct current
..................Class I Construction
..................Class II Construction
(double insulated)
.../min ............per minute
IPM ................impacts per minute
SPM ...............strokes per minute
.................Read instruction manual before use
.....................Use proper eye protection
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for
battery chargers.
WARNING:
charger, battery pack, and product using battery pack.
• Shock hazard. Do not allow any liquid to get inside charger.
• Burn hazard. To reduce the risk of injury, charge only designated PORTER-CABLE
batteries. Other types of batteries may burst causing personal injury and damage.
• Under certain conditions, with the charger plugged in to the power supply, the
charger can be shorted by foreign material. Foreign materials of a conductive nature
such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic
particles should be kept away from charger cavities. Always unplug the charger from
the power supply when there is no battery pack in the cavity. Unplug charger before
attempting to clean.
• DO NOT attempt to charge the battery pack with any chargers other than the ones
in this manual. The charger and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated
PORTER-CABLE rechargeable batteries. Any other uses may result in risk of fire,
electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of
damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number of the wire, the greater the capacity of the
cable, that is 16 gauge has more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual extension contains at
least the minimum wire size.
• Do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not operate charger with damaged cord or plug — have them replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way. Take it to an authorized service center.
• Do not disassemble charger; take it to an authorized service center when service
or repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
(grounded)
Before using charger, read all instructions and cautionary markings on
A ....................... amperes
W ...................... watts
or AC ........... alternating current
or AC/DC .... alternating or direct current
n o ..................... no load speed
n ....................... rated speed
...................... earthing terminal
...................... safety alert symbol
BPM .................. beats per minute
RPM .................. revolutions per minute
sfpm ................. surface feet per minute
.................Use proper respiratory protection
.................Use proper hearing protection
7
Publicidad
