Yamaha A-S2000 Manual De Instrucciones página 12

Controls and functions
Remote control
1
2
3
4
INPUT
1 Infrared signal transmitter
Outputs infrared control signals.
2 Yamaha tuner control buttons
Control functions of Yamaha tuner. Refer to the owner's
manual of your tuner for details.
Note
Some components may not be controlled by this remote control.
3 Yamaha CD player control buttons
Control various functions of Yamaha CD player. Refer to
the owner's manual of your CD player for details.
y
Press once to pause and twice to stop playback.
Note
Some components may not be controlled by this remote control.
12
En
A/B/C/D/E
PRESET
VOL
MUTE
INPUT
VOL
4 Amplifier control buttons
INPUT /
Selects the input source you want to listen to.
Notes
• When MAIN DIRECT is selected as the input source, no
signals are output at the PRE OUT and REC jacks.
• If headphones are plugged into the PHONES jack while MAIN
DIRECT is selected as the input source, no audio is output at
the PHONES jack.
VOL +/–
Controls the volume level.
Note
The VOLUME control does not affect when you select MAIN
DIRECT as the input source. Adjust the volume level using the
volume control on the external amplifier connected to the MAIN
DIRECT jacks.
MUTE
Reduces the current volume level by approximately 20
dB. Press again to restore the audio output to the previous
volume level.
y
You can also press VOL +/– to resume the audio output.
Installing batteries in the remote control
1
3
1
Press the part and slide the battery
compartment cover off.
2
Insert the two supplied batteries
(AA, R6, UM-3) according to the polarity
markings (+ and –) on the inside of the
battery compartment.
3
Slide the cover back until it snaps into place.
2