Control Panel - Vollrath Medio Manual De Uso

MEDIO - GRANDE
EN
INSTALLATION
WARNING! Do not remove the Teflon cover on the sealing bars; do not use knives or other sharp
tools to remove residua from the sealing bar: always wait for the bars to cool down before using
blunt tools.
WARNING! Clean the machine thoroughly after use; clean the plexiglas cover using only a cloth dipped in
water, avoid cleaning liquids and solvents. Use the special products available on the market for cleaning
the stainless steel parts. Do not use water or steam jets as this can damage the machine's electrical
equipment.
In order to clean the suction nozzles, carry out the DEHUMIDIFICATION CYCLE program (fig. 1).
For all problems (defective working or technical assistance) please contact our Customer Service.
5.4

CONTROL PANEL

2
3
1
5
1
VACUUM GAUGE ( 0÷1 bar ): MEASURES VACUUM IN THE VACUUM CHAMBER.
2
THREE-DIGIT DISPLAY
1° DIGIT TO THE LH: INDICATES THE PROGRAM NUMBER ENTERED
2° AND 3° DIGIT: INDICATE THE VALUE RELATIVE TO THE FUNCTION ACTIVATED
• DISPLAY FUNCTION ENTERED:
VAC = VACUUM
SAL = SEALING
• ALSO INDICATES THE NUMBER OF CYCLES CARRIED OUT AND THE OIL CHANGE ALARM.
Once the maximum number of 20000 executed work cycles has been reached, as soon as the appliance is switched on and after every work cycle, the
words ALL" and "OIL" will appear alternately on the display. This is to indicate the need to change the pump oil. Proceed in replacement as indicated
paragraph "CHANGING THE PUMP OIL". The number which appears on the display must be multiplied by 100 (e.g.: the figure 048 indicates that
48x100= 4800 work cycles have been executed).
3
CURSOR PROGRAMS SELECTION:
INCREASES/DECREASES THE VALUES OF THE INDIVIDUAL FUNCTIONS IN THE PROGRAM.
4
PROG PROGRAMMING KEY: MAKES IT POSSIBLE TO ENTER FUNCTIONS PROGRAMMING.
5
VAC VACUUM PROGRAMMING KEY:
MAKES IT POSSIBLE TO ENTER THE VACUUM FUNCTION PROGRAMMING OR TO DISPLAY THE VALUE.
6
SEAL SEALING TIME PROGRAMMING KEY:
MAKES IT POSSIBLE TO ENTER THE SEALING FUNCTION PROGRAMMING OR DISPLAY THE VALUE;
MAKES IT POSSIBLE TO STOP THE ACTIVE OPERATING PHASE AND PROCEED WITH THE NEXT ONE.
7
ON/OFF MAIN SWITCH WITH RED INDICATOR LED:
MACHINE ON/OFF AND INTERRUPT CYCLE.
8
STOP STOP BUTTON: STOPS THE WORK CYCLE.
9
PUMP RUNNING INDICATOR LED.
Operating and service manual / Mode d'emploi et d'entretien
Manual de uso y mantenimiento / Ed. 01 - 2011
Fig. 1
4 8
22
VACUUM PACKING MACHINE
CONDITIONNEUSE SOUS VIDE
MAQUINA DE VACÍO
3
9
6
7
REV. 00 - Cod.: 1500386