Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Follow the next procedure in order to install the U·Vision
device on a control gun:
1. Mount the extension outlet (1) if it is not
already attached.
2. In the case that the control gun has the plastic cover (2)
mounted, remove it by means of a screwdriver or
similar tool. The cover is pressure mounted, it should be
easily removed.
If the flange cover is mounted, remove it as well.
1
BATTERIES INSTALLATION AND REPLACEMENT
2
1
3
2
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
3. Slide the U·Vision
+
outlet (1) untill it remains properly fitted onto the flange.
4. Two kits (4) of nut, bolt and washer are supplied with
the U·vision
indicated in the figure. In the case of the control gun for
dispensing oil use the kit with the M5x25 mm screws
and in the case of the fluid handle use the kit with the
M5x30 mm screws.
2
NOTE: The U·Vision
installed, follow the next steps for proper installation.
1. Loosen the screws (1) with a T15 torx tool and remove
the battery cover (2).
2. Install the supplied batteries (3) checking the polarity as
indicated in the cover (4).
Fig. 5
3. Put back the cover (2) and tighten the screws (1).
WARNING: To ensure battery compartment
!
watertightness, make sure that the battery cover is
properly placed and the screws tightened.
Fig. 6
4
device (3) through the extension
+
device to attach the unit to the flange as
+
4
3
device is supplied without the batteries
+
R. 06/23 838 856
EN
Fig. 7
3
Publicidad
