Manuales relacionados para Truper ROEL-50N2
Resumen de contenidos para Truper ROEL-50N2
- Página 1 Manual Rotary Hammer 11 A Joules Impact Energy Motor ROEL-50N2 Applies for: Code Model 19320 ROEL-50N2 Read this manual thoroughly CAUTION before using the tool.
- Página 2 Contents CAUTION Technical Data Power Requirements To gain the best performance of the tool, prolong the duty life, General Power Tools Safety Warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for Drills of fatal injuries please read and and Hammer Drills understand this Manual before using the tool.
- Página 3 Technical Data ROEL-50N2 Code 19320 Description Rotary Hammer Chuck SDS Plus Voltage 127 V~ Frequency 60 Hz Current 11 A Power 2 Hp Impact Energy 5 Joules Drilling Capacity Concrete: 1-1/4” Steel: 1/2” Wood: 1-9/16” Speed 0 - 800 RPM...
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for Drills and Hammer Drills Choose the right bit While operating the hammer drill CAUTION • The tool is designed to work with • Use the auxiliary handles, if supplied with the tool. SDS-PLUS drill bits or shank accessories. Choose the Loss of control may result in personal injury.
- Página 6 Parts Function Double Vibration Selector Shock Absorber Non-Slip Crankshaft Cap Handle Depth Control Rod Chuck Switch Function Speed Selector Selector Blocking Dust Guard Button 360° Auxiliary Handle Two prong wrench Cord Protector Power Cord Preparation Depth Auxiliary Handle and Depth Control Control Rod Steps 1 &...
- Página 7 Preparation Installing or removing the bit/accessory Bit with SDS-PLUS Shank • Clean and lubricate lightly the bit and / or accessory before installing. • Push the chuck jaw back while turning and pushing the bit/accessory in until it engages. Chuck •...
- Página 8 Start Up Changing the Operation Mode • Turn both function selectors (C) into one of the 2 positions to determine one of the four configurations, depending what is the job to carry out. Never change the position in the WARNING function selectors when the hammer drill motor is running.
- Página 9 Start Up Operation Percussion drill. • Set the knob that changes the drive mode to the symbol • Position the bit at the desired location in the hole, then actuate the switch. • Do not force the tool. With less pressure, you get better results. Keep the tool in the proper position and prevent it from slipping out of the hole.
- Página 10 • However, the user shall add Lithium Complex Grease, ISO 220 Viscosity, N.L.G.I Grade #2 (for more information about the type of grease to use, please contact a Truper Authorized Service Center) every 2 to 3 days, and everyday if the load is heavy or when the impact seems to be weak.
- Página 11 Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center.
- Página 12 Truper will not require any proof of purchase to make the warranty effective. Phone number 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.