Caution; Basic Procedure - Kenwood DPX793BH Manual De Instrucciones

INSTALLATION/CONNECTION
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to
prevent a short circuit.
• To prevent short-circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that come into contact
with metal parts to protect the wires.

Caution

• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during and
shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect them in
parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red) to the
terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on and off by the
ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working
properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old fuse with
one that has the same rating.

Basic procedure

1 Remove the key from the ignition switch, then disconnect the [ terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 39)
3 Install the unit to your car.
See Installing the unit (in-dash mounting). ( 38)
4 Connect the [ terminal of the car battery.
5 Press to turn on the power.
6 Reset the unit. ( 3)
Part list for installation
(Parts supplied for /
(A) Mounting sleeve
(C) Trim plate (only for Toyota car)
(Parts supplied for all models)
(E) Wiring harness
/ )
(B) Trim plate
(D) Extraction key
(F) Round head screws
(M5 × 8 mm)
(G) Flat head screws
(M5 × 8 mm)
37
ENGLISH