Kenwood DPX793BH Manual De Instrucciones página 42

INSTALLATION/CONNECTION
(For / /
Installing the unit (in-dash mounting)
Do the required wiring.
( 39)
Dashboard of
your car
Installing in Toyota cars
Install onto the car brackets using screws (F) or (G) (supplied). Use the mounting holes (
car brackets. Then, install the supplied trim plate (C).
Do the required wiring.
( 39)
Dashboard of your car
38
ENGLISH
)
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
) or (
Car bracket
When installing without the mounting sleeve
Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied).
* For
Remove the mounting sleeve and trim plate from the unit
before installing.
Use only the specified screws. Using wrong screws might
damage the unit.
) that fit the
(For
How to remove the unit
1 Fit the catch pin on the extraction keys into the holes on
both sides of the trim plate, then pull it out.
2 Insert the extraction keys deeply into the slots on each
side, then follow the arrows as shown on the illustration.
/ / :
/ / )