Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
11. Lift and pull the L-shaped pivot pin on the
edge of the left door (I), aligning the
assembling holes in the door support
bracket (L) and top panel (F), then
release. Repeat for right door (J).
Note: Check and see if the top panel (F) is
level. If not level due to uneven floor, the
two doors will probably not be properly
aligned. In this case, use an adjustable
wrench (not included) to adjust the hex nut
until the top panel (F) is level.
12. Screw one end of wall strap (EE) to the
right back panel (B) with #8-32 x 3/8 in.
bolts (BB) and #8-32 nuts (CC). Secure
the other end to the wall with ST4 x 20
mm screws (DD). Repeat for another wall
strap (EE).
Note: This cabinet should be anchored to the
wall using the wall strap (EE) to avoid any
potential danger from cabinet falling. Check
and see if the top panel (F) is level. If not level
due to uneven floor, the two doors will
probably not be properly aligned. In this case,
use an adjustable wrench (not included) to
adjust the hex nut until the top panel (F) is
level.
Hardware Used
#8-32 x 3/8 in. Bolt
BB
#8-32 Nut
CC
ST4 x 20 mm
DD
Screw
EE
Wall strap
11
I
12
F
D
x 4
BB
x 4
x 4
x 2
CC
11
L
A
EE
B
DD
EE
F
J
Wall
Publicidad
