Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
13. Move the unit to the wall, making sure the
back of the unit is flush with the wall.
Feed the ST4.8 x 100 mm pan head
screws (HH) through the 5 x 15 x 1.2 mm
washers (II) and back panels (A and B).
Screw the ST4.8 x 100 mm pan head
screws into wall studs, and tighten
securely.
Note: Screws must be placed into wall
studs. The unit will not be secured if
screwed into drywall. If there is a gap
between the unit and the wall due to
moulding on the garage floor, please make
the unit press against the moulding and be
parallel to the wall.
Hardware Used
ST4.8 x 100 mm Pan
HH
head screw
13
II
x 2
II
12
A
Wall
HH
5 x 15 x 1.2 mm
Washer
B
x 2
Publicidad
