Kobalt 19005 Instrucciones De Montaje página 9

ASSEMBLY INSTRUCTIONS
7. Hold the slides on small drawer (M) while
aligning them with the slides on side
panels (C and D). Slightly insert one side
and repeat for the other side. Slowly push
the drawer until it is fully closed to engage
the slides. Open and close the drawer to
verify proper operation.
8. Fold two right angles on the big drawer
bottom panel (N) on the dotted lines.
Tighten ST4.8 x 10mm screws (AA) to the
edge of big drawer back panel (O) to
connect it to the big drawer bottom panel
(N). Repeat to assemble the big drawer
front panel (P) to the unit.
Note: Make sure the sides with slides are
outward when folding the big drawer bottom
panel (N). Big drawer back panel (O) is
attached to the big drawer bottom panel (N)
with the edge that slides overhang the panel.
Hardware Used
AA
ST4.8 x 10 mm
Screw
7
tooltip tooltip tooltip tooltip tooltip tooltip
M
M
8
AA
x 20
9
C
N
N
O
O
N
D
P
P