Publicidad
Idiomas disponibles
Idiomas disponibles
GB
F
D
FEATURES
KNOW YOUR MULTI PAD SANDER (Fig. 1)
Your sander is suitable for sanding with coarse, medium,
and fine grit sandpaper. It will produce a fine scratch free
finish when used to sand with the grain on wood surfaces.
It has been designed so that flush corner sanding on
three sides of the sander is possible.
Your sander has a comfortable palm grip handle that
provides maximum one-hand comfort, and reduces
operator fatigue during continuous sanding operations.
Before using this product, familiarize yourself with all
operating features and safety requirements.
However, do not let familiarity with the tool make you
careless.
EXCHANGEABLE HOOK AND LOOP BASE
PADS
This sander includes 3 base pads which are
interchangeable for different applications.
Triangular Detail Pad (6) for detail sanding.
■
1/3 Sheet Pad (7) for sanding large areas.
■
Random Orbit Pad (8) for a fine finish.
■
The hook and loop design allows for quick change of
sanding sheets and different pads. It also enables you to
easily clean and reuse them.
SWITCH (1)
This tool is equipped with a simple switch control located
near the front of the motor housing.
CIRCULAR SANDING ACTION
The oscillating action of your sander produces very quick,
small circular motion of the sanding pad. The motion is
ideal for producing a fine finished grain.
DUST COLLECTION BAG (3)
The dust bag attaches to the sander and keeps dust to a
minimum.
PAPER HOLE PUNCH FOR 1/3 SHEET PAD (9)
The paper punch template punches sandpaper (12) for
proper fit and alignment.
VARIABLE SPEED CONTROL (4)
Your sander has advanced electronic features,
designed to assist you in getting the maximum use from
your sander.
E
I
P
NL
S
DK
N
FIN
GR
English
By making proper speed selections, your sander can be
adjusted to specific sanding needs.
The variable speed control allows the sander to develop
a no load speed that can be adjusted from 6,000 to
12,000 min
conveniently located on the front of the sander.
The electronic feature of your sander introduces the
flexibility of adjusting the motor speed to required job
conditions. An electronic speed control module senses the
load applied to the motor and increases or decreases motor
voltage to compensate for and maintain desired RPM.
Speed can be set according to the sanding purpose or
work-piece's surface you will be using.
Selector clockwise to increase speed for the rough
surface or for quick removal of stock and anti-clockwise
to decrease speed for the smaller delicate sanding
applications.
OPERATION
TURNING THE SANDER ON/OFF (Fig. 2)
Follow these steps to turn the sander ON/OFF:
Turn on the sander: Push the ON/OFF switch to
■
the left.
Turn off the sander: Push the ON/OFF switch to
■
the right.
OPERATING THE SANDER (Fig. 3)
Follow these steps to operate the sander:
Secure the workpiece to prevent it from moving under
■
the sander.
Place the sander on the workpiece so that all of the
■
sanding disc surface is in contact with the workpiece.
Turn on the sander and move it slowly over the
■
workpiece.
11
RO
H
CZ
RUS
. The variable speed control selector is
-1
WARNING
Unsecured workpieces could be thrown towards
the operator, causing injury.
WARNING
Keep your head away from the sander and the
sanding area. Your hair could be drawn into the
sander causing serious injury.
CAUTION
Avoid damaging the motor from overheating,
be careful not to let your hand cover the air vents.
HR
PL
SLO
TR
Publicidad
