UFESA Goteborg Manual De Instrucciones página 16

damaged: if in doubt, check with professional qualified technician.
The socket must be easily accessible in order to be able to disconnect the appliance with ease
in case of emergency.
Do not place the unit on top of a shelf and/or near a wash basin or any container with of liquid
(leave a distance of at least 2 metres) to prevent the risk of it falling into the liquid.
Place the fan away from fabrics (curtains, etc.) or volatile materials that may obstruct the ven-
tila- tion grille; also check that the front of the fan is free of volatile materials (dust, etc.).
Place the appliance away from all heat sources (e.g. naked flames, gas stoves, etc.).
The supporting surface must be stable and flat and even (so that the appliance does not tip
over).
Place the fan away from fabrics (curtains, etc.) or volatile materials that may obstruct the ven-
tilation grille; also check that the front of the fan is free of volatile materials (dust, etc.).
Place the appliance away from all heat sources (e.g. naked flames, gas stoves, etc.).
The supporting surface must be stable and flat and even (so that the appliance does not tip
over).
ASSEMBLY
Warning: the fan may only be used if it is fully and correctly assembled, i.e. with the base
and pro- tection grille.
Warning: always disconnect the appliance from the mains supply before assembling.
If in doubt, have a qualified, professional technicin check the appliance or assemble it. To
assemble the fan, use the following figures in the diagram as a reference.
1.Install rear grille (fig.1).
Align the rear grille to the fan assembly.
2. Secure the rear grille nut (fig.2).
3.Insert fan blade (fig.3).
(1)Slide the fan blade into the blade slot until it is fully inserted into the shaft pin.
(2)Screw on the blade knob tightly in an ati-clockwise direction.
4.Install front grille (fig.4).
Mount the front grille(logo in upright position) with the rear grille with the top U clip.
Fasten the 4 clip around the grille.
Tighten the ring lock with a screw driver (fig.5).
5. Pass the power cord through the base plate (fig.6).
6 .Insert the motor assembly into the base plate (fig.7).
7. Twist clockwise to lock (fig.8).
8. Insert the power cable into the base plate catch at the rear of the base plate (fig.9).
USE
Before each use, check that the appliance is in good condition and that the power cord is
not dam- aged: If the power cord is damaged, request that it be changed by the manufac-
turer's technical sup- port service or a person with a similar qualification, in order to avoid
any danger.
Plug the appliance into the mains socket.
Ventilation: select the desired speed using the corresponding buttons (Fig.10):
16