Publicidad
Idiomas disponibles
Idiomas disponibles
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems
Possible cause
The appliance is
Power plug is not
connected to the
connected properly
power supply but
to the electrical
does not function.
power.
The circuit breaker
tripped or a blown
fuse.
Temperature inside
Temperature is set
the appliance is too
too warm.
warm.
Door is kept open
too long.
The door gasket
does not seal
properly.
Moisture forms on
Door is kept on for
the inside appli-
too long.
ance walls.
Too much Vibra-
The appliance is
tion.
not placed level.
The door will not
The Wine Cooler is
close properly.
not placed level.
The door was
reversed and not
properly installed.
The shelves are out
of position.
Error code identification
Error codes
"E1" or "E2"
"E3" or "E4"
Possible solution
"E7" or "E8"
Check again
to make sure
it is connected
properly.
Contact the
supplier.
Turn to a cooler
"HH" with
setting.
beep sound
Open door less.
Check to make
sure the door gas-
ket seal properly.
Open the door less.
Check the level
and adjust the feet
until the wine cool-
er is level. (Minor
vibration is normal)
"LL" is flashing
Check the level
with beep sound
and adjust the
and the compres-
feet until the wine
sor is stopped
cooler is level.
operation.
Contact the
supplier
Check and put the
shelves on right
position.
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
ranty, state where and when it was purchased and include proof
of purchase (e.g. receipt).
Possible cause
Possible solution
1. The connection
Reconnect
of upper zone
the sensor
temperature
sensor is loose.
2. Upper zone
Contact the
temperature
supplier.
sensor is
defective.
1. The connec-
Reconnect
tion of defrost
the sensor
sensor is loose.
2. Defrost sensor
Contact the
is defective.
supplier.
1. The connection
Reconnect
of lower zone
the sensor
temperature
sensor is loose.
2. Lower zone
Contact the
temperature
supplier.
sensor is
broken.
1. Gas leakage.
Contact the
supplier.
2. The capillary
copper tube
on the strainer
beside the
compressor
is blocked.
3. The evaporator
fan is defective.
4. High tempera-
ture alarm (the
temperature
in the wine
cabinet over
78.8°F/26°C)
1. The fan of heat-
1. Disconnect
er is stopped.
the power and
connect it again
2. The control pan-
after 5 mins.
el is abnormal.
2. Contact the
supplier
3. The heater is
defective.
4. Low temper-
ature alarm
(temperature in
the wine cabinet
below 32°F/0°C)
GB
13
Publicidad
