3.
INSTALLATION INSTRUCTIONS
Location
When selecting a location for your appliance you should make sure the floor is flat and firm,
and the room is well ventilated. An average ambient temperature must be observed.
This temperature is specific according to the climatic class of the device:
•
N: This refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 32 °C
•
ST: This refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 38 °C
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight in
out-buildings or terraces/outside seating areas. If you are placing your appliance in an out-
building such as a garage or annex ensure that it is placed above the damp course,
otherwise condensation will occur on the cabinet. Never place the appliance in a wall
recessed or into fitted cabinets or furniture when it is working, the metal grid at the back may
become hot and the sides warm.
This refrigerating appliance is not intended to be used as a built-in appliance. Never place
the Fridge/Freezer in a wall recessed or into fitted cabinets or furniture when your
Fridge/Freezer is working, the grille at the back may become hot and the sides warm. It must
therefore be installed so that the back of the Fridge/Freezer has at least 10 cm of free space
and the sides have. Do not drape the Fridge/Freezer with any covering.
Recommendation combination:
The following combination of drawers, baskets, and shelves is recommended for energy to
be used as efficiently as possible by the refrigeration unit.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment will be
affected and may cause a malfunction. Once the appliance is placed in its
final location, adjust the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse
with warm water using a damp sponge or cloth. Wash the baskets and shelves in warm
soapy water and dry completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
26