EN
1
DESCRIPTION
1.1
PURPOSE
This machine is used for domestic lawn mowing. The
cutting blade must be approximately parallel to the
ground. All four wheels must touch the ground while you
mow.
1.2
OVERVIEW
Figure 1-9.
Start button
1
Upper handle
2
Lower handle
3
Handle Knob
4
Cam lock
5
Height adjustment lever
6
Quick-release lever
7
Battery door
8
Mulch plug
9
Rear discharge door
10
Grass catcher
11
Battery pack
12
Safety key
13
Bail switch
14
Slot
15
Blade
16
Mounting screw
17
Spacer
18
2
SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until
you assemble all the parts.
WARNING
WARNING
WARNING
English
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2
UNFOLD AND ADJUST THE
HANDLE
Figure 2.
1. Pull up and back the upper handle to lift the handle
into operation position. Make sure that the handles
click into position correctly.
2. Tighten the lower handle with the quick-release
levers on the two sides.
3. Tighten the upper handle with the cam locks on the
two sides.
Make sure that the two handles are in the same
position.
Do not make damage to the cables when you fold or
unfold the handle.
3.3
INSTALL THE GRASS CATCHER
Figure 3.
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and engage
the hooks on the slots.
4. Close the rear discharge door.
3.4
INSTALL THE MULCH PLUG
Figure 4.
1. Remove the grass catcher.
4
WARNING
WARNING
NOTE
WARNING