DECLARATION OF CONFORMITY
Ventilairsec declares that the VMI
Directive 2014/30/EU on electromagnetic compatibility
•
Directive 2014/35/EU on low voltage electrical equipment
•
Directive 2014/53/EU on radio equipment
•
Directive 211/65/EU on the restriction of the use of hazardous substances in electrical
•
and electronic equipment
The main applicable requirements of the RED directive 2014/53/EU
EMC:
•
o ETSI EN 301 489‐3: 2019 V2.1.1 with standard ETSI EN 301 489‐1: 2019 V2.2.3:
Short-range devices operating in the 9 kHz to 246 GHz frequency range
o EN 55014-1 2017: Mains-powered devices
o EN 55014‐2: 2015: Category 4 devices (F>15 MHz)
o EN 61000‐3‐2: 2006 / A1: 2009 / A2: 2009: Limits for harmonic current emissions
o EN 61000‐3-3: 2013: Limitation of voltage changes, voltage fluctuations and
flicker in public low-voltage supply systems, for equipment with rated current
inferior or equal to 16 A per phase and not subject to conditional connection
Radio frequency:
•
o EN 300220-2 V3.1.1
o EN 300328 V2.1.1
EMF EN 62479 (2010)
•
•
Low voltage:
o EN 60335-2-30:2009 + A11:2012
o EN 60335-2-80:2003 + A1:2004 + A2:2009
o EN 60335-1:2012 + A11:2014 + A13:2017
o EN 62368-1:2014
Ventilairsec confirms that the EMC, EMF, Radio and Electrical safety tests have been performed
by a certified body. The official declaration of conformity is available upon request.
The EC marking is placed on the product - year: 2023
Ventilairsec confirms that the VMI
dielectric strength tests.
A test has been performed on this product to validate the essential safety aspects in accordance
with Appendix A of the NF EN60335-1:2012 standard. These routine tests are carried out by
Ventilairsec on each VMI
production variations that could affect the safety of the products. These tests are performed on
the completed VMI
®
CUBE VISION'R unit is conform:
®
®
CUBE VISION'R unit complies with the ground continuity and
unit that leaves their production plants in order to detect any
®
unit ready to ship, as recommended by the standard.
93