Publicidad
Idiomas disponibles
Idiomas disponibles
HEPA FILTER REMOVAL & REPLACEMENT: CONTINUED
5.
4.
To replace: Insert HEPA filter
Lift filter cover back into place.
into housing (gasket on
inside) and push into place.
BELT STORAGE
TOOL REQUIRED: PHILLIPS SCREWDRIVER
Belt, part # 3-910340-600, is located on the side of cleaner.
BELT STYLE
For Belt Style 12 replacements, please call 1-800-321-1134 or visit our website at
12
www.royalvacuums.com to locate a dealer nearest you.
1.
2.
Loosen the one (1) screw
Gently
lower
filter
located at the top of filter
cover from body.
cover.
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
2.
1.
Flip cleaner to expose nozzle base.
Lift and remove brushroll.
Base should lay flat and face up. To
remove nozzle guard, use Phillips
screwdriver to remove the six (6)
screws. Arrows show location of
screws. Lift nozzle guard off.
6.
Secure the one (1) screw at
the top of filter cover.
3.
4.
Belt is stored on the inside
Replace
filter
of the filter cover on top.
Secure the one (1) screw
Remove and replace with
at the top of filter cover.
another NEW belt.
3.
Slide old belt off motor shaft.
Dispose of old belt.
9
BELT OR BRUSHROLL REMOVAL & REPLACEMENT: CONTINUED
4.
Place belt on motor shaft,
then slip brushroll through
belt. Place belt in area of
brushroll without bristles.
TOOL REQUIRED: PHILLIPS SCREWDRIVER
NOTE: Unplug cleaner before checking dirt path or filter.
DIRT PATH MAINTENENCE
1.
cover.
Pull release lever
and lift to remove
bag compartment.
FILTER MAINTENENCE
1.
Pull release lever on the bag
compartment. Pull away
from cleaner.
5.
5a.
With belt in place, pull and slide
brushroll into nozzle making
sure that the brushroll end caps
are in the correct orientation
(5a). IMPORTANT: ROTATE
BRUSHROLL MANUALLY TO
MAKE SURE BELT IS NOT
TWISTED.
GENERAL MAINTENANCE
2.
3.
Unscrew the two (2)
Remove the access panel
screws located on the
and remove all visible
inside of the cleaner.
debris.
2.
Remove filter and shake out
loose dirt. Replace filter.
10
6.
Reattach nozzle guard. Secure by
replacing the six (6) screws.
4.
4a.
Replace
access
panel.
Secure by replacing the two
(2) screws (4). Return bag
compartment to its position
(4a).
3.
Replace bag compartment.
For filter replacement part
#1-910115-000,
please
call 1-800-321-1134.
Publicidad
