Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHTBULB: REMOVAL & REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1134
or your local auto parts store.
2.
1.
Put cleaner into an upright
Pull bulb out of socket to
position. Remove the two (2)
remove. Do NOT twist. Push
screws located on either side
bulb into socket to replace.
of the headlight lens.
3.
Secure the headlight lens by
replacing
the
screws.
11
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM
Cleaner won't run
Cleaner won't
pick-up or low
suction
two
(2)
Dust escaping
from cleaner
Cleaner tools
won't pick-up
Headlight not
working
Cleaner is difficult
to push
Brushroll not
rotating
Belt burns or
breaks
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
transportation to and from any place of repair are to be paid by the owner. The service parts used in this unit are
easily replaced and readily available from an authorized Royal
the model number and manufacturing code when requesting information or ordering replacement parts. (The model
number appears on the bottom of the cleaner.)
TROUBLESHOOTING GUIDE
POSSIBLE REASON
POSSIBLE SOLUTION
1. Power cord not firmly plugged into
1. Plug cord in firmly.
outlet.
2. Blown fuse or tripped breaker.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Needs service.
3. Take to service center or call 1-800-321-1134.
1. Paper bag full.
1. Replace paper bag - Pg. 8
2. Paper bag not installed correctly.
2. Insert finger into hole and push paper away
from opening OR review paper bag removal and
replacement - Pg. 8.
3. Broken or worn belt.
3. Review belt removal and replacement - Pg. 9, 10.
4. Carpet height setting is incorrect.
4. Set carpet height adjustment to appropriate
setting for carpet being cleaned - Pg. 7.
5. Unit misassembled resulting in air
5. Reassemble unit / review assembly - Pg. 6.
flow leakage.
6. Dirty HEPA filter.
6. Replace HEPA filter - Pg. 8, 9.
7. Brushroll worn.
7. Review brushroll removal and replacement - Pg. 9, 10.
8. Dirty bag chamber filter.
8. Review general maintenance - Pg. 10.
1. Paper bag full.
1. Replace paper bag - Pg. 8.
2. Paper bag not installed correctly.
2. Review paper bag installation - Pg. 8.
3. Puncture/hole in paper bag.
3. Replace paper bag-Pg. 8. Clean/replace filters -
Pg. 8, 9.
4. No bag in cleaner.
4. Install bag & clean filter - Pg. 8, 9.
5. Dirty bag chamber filter.
5. Review general maintenance - Pg. 10.
1. Hose clogged.
1. Remove hose and tools; remove obstruction - Pg. 7.
2. Bag inlet clogged.
2. Remove hose (Pg. 7) and paper bag (Pg. 8).
3. Paper bag full.
3. Replace paper bag - Pg. 8.
4. No bag in cleaner, filter clogged.
4. Install paper bag (Pg. 8) and clean filter (Pg. 8, 9).
1. Bulb burnt out.
1. Replace bulb - Pg. 11.
2. Loose electrical wires.
2. Call 1-800-321-1134 for nearest authorized
Royal
1. Carpet height setting is incorrect.
1. Set carpet height adjust lever to appropriate
setting for carpet being cleaned - Pg. 7.
1. Broken belt.
1. Review belt removal and replacement - Pg. 9, 10.
2. Brushroll jammed with an
2. Turn the unit off and unplug. Remove the
obstruction.
obstruction. Plug unit back into outlet and turn
the power to the "on" position.
1. Brush may be jammed with debris.
1. Remove brushroll - Pg. 9, 10. Clean brush of debris.
2. Brush end caps are clooged with
2. Remove brushroll. Determine if end caps
debris.
rotate freely. If not, replace brushroll - Pg. 9, 10.
3. Carpet height setting is incorrect.
3. Set capet height adjustment to appropriate
setting for carpet being cleaned - Pg. 7.
CUSTOMER SERVICE
(1-800-321-1134)
®
Dealer or retailer. Always identify your cleaner by
12
®
Dealer.
®
Dealer. Costs of any
Publicidad
