Uline H-259 Manual De Instrucciones página 3

3. Brush the treads of the feed wheel with a wire brush
to remove dirt and particles.
4. Put the washers into place on the back of the feed
wheel. The smaller washer is placed directly on the
back of the feed wheel and the larger spring washer
sits over it with the flat side resting on the feed wheel.
The third washer follows the spring washer.
(See Figure 6)
Figure 6
Cover Plate
Screw
NOTE: H-259 has a fourth washer.
5. Push the spacing cam to the right and put the feed
wheel in place.
6. Tighten the bolt to secure the wheel.
ADJUSTING THE TRACKING ON THE LOWER FEED
ROLLER ASSEMBLY
1. Turn the machine upside down.
2. To raise the feeding of the oil board above a guide
line, turn the inside nut clockwise. (See Figure 7)
3. To lower the feeding of the oil board below a guide
line, turn the outside nut counterclockwise.
(See Figure 7)
4. Tighten the opposite nut after making the
adjustment, but be careful not to overtighten it.
PAGE 3 OF 15
MAINTENANCE CONTINUED
Nut
Square Head
Screw
Figure 7
Outside Nut
5. Feed the oil board through the machine after each
adjustment to test the setting of the nuts.
ADJUSTING THE PUNCH DEPTH
1. Loosen the five screws on the front cover plate.
2. Remove the handle screw and washer and pull the
cover plate and handle assembly away from the
machine and place it to the side.
3. Loosen the nut shown in Figure 6 by turning it
counterclockwise.
4. Adjust the square head screw to the desired position.
Only turn the square head screw 1/4 turn at a time.
If you want to apply more punch depth, turn the
square head screw clockwise. If you want to apply
less punch depth, turn the square head screw
counterclockwise.
5. After the adjustment is made, tighten the nut to
secure the position of the square head screw.
6. Replace the cover plate and handle assembly by
tightening the five cover plate screws, the washer
and handle screw.
7. Test the setting of the punch depth after each
adjustment by cutting a piece of oil board.
REPLACING A PUNCH AND DIE
1. Turn the machine upside down.
2. Locate the punch and die that need to be replaced.
3. Loosen the two screws in the die and remove it.
(See Figure 8)
Lower Feed
Roller Assembly
Inside Nut
0521 IH-259