Publicidad
Idiomas disponibles
Idiomas disponibles
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling
canopy with the two screws in the
mounting plate. Push up to engage the
slots and turn clockwise to lock in place.
Immediately tighten the two mounting
screws firmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws in
the canopy. Rotate the ring clockwise to
lock in place.
7.
Attaching the Switch
Cup
1. Remove one screw and loosen but do not
remove two screws from keyhole slots on
the motor assembly. (Figure 13)
2. Pass wires through center hole of switch
cup and position the switch cup on to the
motor assembly, turn switch cup counter
clockwise to engage screws into keyhole
slots. Re-install the screw removed in
the first step and tighten screws that were
loosened from the motor assembly.
3. Remove pre-installed screws from the
switch box cover and position the switch
box cover onto the switch box. (Figure 14)
4. Re-install screws removed in previous step
and tighten.
Motor
Assembly
Mounting screw
Figure 12
Switch cup
Switch cup
Figure 13
Pre-installed
screws
Switch cup cover
Figure 14
Publicidad
