Baby Jogger city tour 2 Manual De Instrucciones página 11

FRAME
1 Unpack the stroller frame from the box
and set the wheels aside.
Unlock the stroller by pulling the auto-
lock lever.
2 Pull the lower front frame of the stroller
away from the rear legs. Then, lift the
seat back frame upwards from the
rear legs. Lastly, unfold the handlebar
upwards. The stroller will lock into
position and you will hear a click.
3 Place the stroller in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Attach front wheels by sliding them
into the front wheel mount until it
clicks. Gently pull on the front wheel to
make sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount.
SWIVEL FEATURE
6 Push the swivel lock button up to lock
the front wheel to a fixed position.
7 Press the swivel lock button down
to allow the front wheel assembly to
swivel.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame and
insert it into the wheel mount until it
locks into place. You will hear a click.
• Gently pull on the rear wheel to make
sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
BRAKE
10 To lock the brakes: push the brake
lever down to engage the brakes.
11 To release the brakes: lift the brake
lever up.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
CANOPY
12 Pull forward to open canopy, push
backwards to close canopy.
13 To use the canopy extension: Pull the
extension out from under the canopy
until it snaps into place, push the
extension under the main canopy to
hide.
ADJUSTING SHOULDER STRAPS
14 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the plastic board and seat fabric.
15 Reinsert stopper at seat opening
closest to child' s shoulders. Pass back
through seat fabric and plastic board.
Tug on strap to ensure stopper is
locked. Repeat on both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch
strap in combination with the shoulder
straps and waist belt.
16 Slide the harness pads up to access
plastic guide on strap.
17 Hold the plastic guide and pull strap to
tighten or loosen.
USING SAFETY HARNESS
18 Insert side strap buckle into harness
buckle on both sides.
19 Insert connected harness and side
strap buckles into the sides of the
crotch buckle.
20 Press button on crotch buckle to
release.
RECLINE THE BACKREST
21 Pinch the clamp behind the backrest,
and slide it down to desired position.
22 Pull backrest down on both sides to
match the clamp position. Reverse
steps to return to the upright position.
11
EN