BEARWARE 302688 Manual página 26

8.2 Alarm setting
The weather station can store up to 2 alarm settings, which can be turned on and
off separately at the side using a flip switch. By pressing the "MODE" button you
can view the configured alarm times. The alarm times are shown at the place
where the date is displayed normally.
Setting the alarm
Press and hold the "MEM" button for about 3 seconds to access the alarm
settings. The alarm time is now displayed instead of the date. You can make the
desired settings using the "+" and "-" buttons. Then press the "MEM" button
again to save the alarm setting. You can configure these settings using Alarm 1
(A1) and Alarm 2 (A2). Confirm your entry using the "MEM" button.
Turning the alarm on and off
After setting the alarm successfully, you can turn it on or off using the flip switch
located on the side.
Muting the alarm
When the alarm is activated at the configured time, the backlight also turns on
automatically. The alarm is active for 2 minutes before it turns off automatically. If
the alarm does not turn off within these 2 minutes, then it repeats automatically
after 24 hours.
Press the "SNOOZE/LIGHT" button to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze function is activated and the
alarm will go off again in 5 minutes.
Place the flip switch on the side of the device to the "OFF" position to turn off the
alarm.
26
English