Publicidad
Idiomas disponibles
Idiomas disponibles
Using the steering wheel remote
control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 is
required before use.
1
Select [Settings] [System] [Steering
Wheel Settings].
2
Set the [Custom] switch to [On].
You can make the registration to enable the
steering wheel remote control.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable
RC-SR1
REMOTE IN
Black
Green
Brown
• Refer to the support site for details, then connect
each lead properly to the appropriate leads.
Making an improper connection may damage the
unit.
URL: https://www.sony.com/am/support
• Consulting the dealer or an experienced
technician for help is recommended.
• When connecting the iDataLink Maestro module
(not supplied), do not connect any device to the
REMOTE IN terminal (blue). Likewise, when
connecting a device to the REMOTE IN terminal
(blue), do not connect the iDataLink Maestro
module (not supplied) to the IDATA LINK I/F
terminal (black).
When using an adaptor for the steering wheel
remote control
Depending on the type of car, use an adaptor for
the steering wheel remote control (not supplied).
1
Select [Settings] [System] [Steering
Wheel Settings].
2
Set the [Custom] switch to [Off].
The adaptor for the steering wheel remote
control is enabled.
GND
Input 1
Input 2
Using a USB device
Installation of the USB Type-C extension cable is
required before use.
1
Connect the USB Type-C extension cable
to the USB port at the back panel of the unit.
2
Pass the cable tie through the cable
holder, then tie the cable tie around the
USB Type-C extension cable .
The USB Type-C extension cable is secured to
the unit.
3
Connect the installed USB Type-C extension
cable to a USB device.
4
Press HOME, then touch [USB].
13
GB
Publicidad
