SUHNER ABRASIVE LLE 18-TOP Documentación Técnica página 16

1. N
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LLE
18-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and grinding
attachments.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 P
rior to tAKing the mAchine into serVice
Si raccomanda aria compressa oleosa(see
also air quality under section 2.3). Ob-
serve national regulations.
2.1.1 f
itting of hose couPling
Fitting of hose coupling inside diameter min. 7mm (avail-
able as optional accessory, item no. 90805700).
16
S
oTES oN aFETy
ommISSIoNINg
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Max. wheel diameter
Max. chuck diameter
Sound pressure level EN ISO 15744 75dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 o
PerAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
3.1 t
ools
Use only clean tools!
3.1.1 c /f
hAnging itting the tool
max. 6.3bar
600W
1.05m /min
3
1.3m /min
3
about 5-6 drops/min
20000min
-1
50mm
10mm / 3/8"
4.7m/s , K=1.3m/s
2 2
3/4/4
1.600kg
/ o
PERaTIoN