Recommended Treatment Schedule - Beurer IPL 7500 Manual De Instrucciones

device; one green Level LED will illuminate indicating the
device is set to Energy Level 1. To increase the Energy
Level, press the On/Off/power selection button repeat-
edly to select Energy Level 2 or 3.
Select the energy level according to your convenience,
as determined in the preliminary test for that treatment
area.
2. Position the treatment window onto the desired area of
skin, making sure it makes full contact. If the treatment
window is not properly positioned, the Power LED will
briefly change to orange. If your skin tone is too dark/
tanned, the Power LED will briefly change to red. In either
case, the device will not operate.
3. Press the trigger button for a single pulse or press and
hold for continuous operation. After the first pulse, the
internal fan in the device may switch on.
4. When pressing the trigger button you will see a bright
flash, hear a popping noise, and may feel a mild sting-
ing and/or heating sensation.
5. Keep the trigger button pressed and move the device to
a different area after each pulse while keeping it in con-
tact with the skin. Continue until the entire treatment area
has been covered.
6. After treatment, shut the device off by pressing and hold-
ing the On/Off/power selection button for three seconds;
the orange LED will illuminate while the device is in shut-
down mode, followed by blinking green which indicates
the device is in standby mode. Unplug the device after
each treatment session.
CAUTION
• Do not overlap pulses in the same spot. Repeated
pulses on the same spot may cause burns.
• Do not treat the same area of skin more than once per
treatment as it may cause skin irritation.
• The device will not trigger a pulse if:
a. There is no full contact of the treatment window with
the body skin.
b. Your skin tone is too dark or tanned.

Recommended Treatment Schedule

Body Hair Color
Fitzpatrick
Skin Tone
14
Light to Dark Brown
Medium Brown to Black
1-4 1-4