Sony SDM-M81/B Manual De Instrucciones página 17

Technical Features
Power saving function
This monitor meets the power-saving guidelines set by VESA,
E S
NERGY TAR, and NUTEK. If the monitor is connected to a
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, the monitor will automatically
reduce power consumption as shown below.
Power mode Power consumption
normal 50 W (max.)
operation
active off* 3 W (max.)
(deep sleep)**
power off 3 W (max.)
* When your computer enters the "active off" mode, the input signal is
cut and NO INPUT SIGNAL appears on the screen. After 20 seconds,
the monitor enters the power saving mode.
** "Deep sleep" is a power saving mode defined by the Environmental
Protection Agency.
Automatic picture quality
adjustment function
When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor's memory to provide a high quality picture at the center
of the screen. (See the Appendix for a list of the factory preset
modes.)
For input signals that do not match one of the factory preset
modes, the automatic picture quality adjustment function of this
monitor automatically adjusts the picture position, phase, and
pitch, and ensures that a clear picture appears on the screen for
(power)
1
any timing within the monitor's frequency range (horizontal: 28 –
indicator
92 kHz, vertical: 48 – 85 Hz).
green
Consequently, the first time the monitor receives input signals
that do not match one of the factory preset modes, the monitor
may take a longer time than normal for displaying the picture on
orange /
the screen. This adjustment data is automatically stored in
green and orange
memory so that next time, the monitor will function in the same
alternate
way as when the monitor receives the signals that match one of
off
the factory preset modes.
In all modes mentioned above, if the picture is adjusted, the
adjustment data is stored as a user mode and automatically
recalled whenever the same input signal is received.
Note
While the automatic picture quality adjustment function is activated, only
the 1 (power) switch will operate.
GB
17