Cub Cadet FT24 Manual De Operación página 8

3. Insert the horizontal bracket into the chain case brackets
and secure the depth stake assembly in place with the
screws just removed in step 1. See Figure 3-3.
NOTE: The depth stake can be placed at various positions.
For setup purposes it is suggested that the depth stake
be assembled with the stake just above or level with the
ground surface. See the Operation section for instructions
on setting the tilling depth and adjusting the depth stake.
Handle
The handle is tilted down and packaged loose for shipping
purposes. To attach the handle, proceed as follows:
1. Remove the bolts, washers and nuts from the chain case
bracket. See Figure 3-4.
2. Place the handle into position and secure with the
previously removed hardware. See Figure 3-4.
8 S 3— A
ection SSembly
Figure 3-4
& S -U
et p
3. Remove the handle adjustment crank from the handle. See
Figure 3-5.
Figure 3-5
4. Rotate the handle upward and secure it in place with the
handle adjustment crank. See Figure 3-5.
5. When the handle is in place, insert the clutch cable into the
cable guide on the handle as shown in Figure 3-6.
Figure 3-6