Special Product Features; Use; Switching On And Off; Selection Of Direction Of Rotation - Metabo SE 4000 Instrucciones De Manejo

17026689_1107 NAFTA SE 4000_SE 28.book Seite 7 Dienstag, 13. November 2007 10:24 10
7 Tool *
8 Quick-release lock
9 Stop sleeve
* depending on equipment/not in scope of delivery

5 Special Product Features

• Compact, light machine in barrel-type design
for continuous use
• Ergonomically designed housing for effortless
work
• Patented bit changing system
• Two-piece depth stop
• Fine adjustment of insertion depth
• Low-noise claw clutch
• Removable scaffold hook with integrated bit
depot (depending on equipment)
• SE 4000:
Ideally suited for applications in dry construc-
tion, e.g. installation of gypsum plasterboards.
• SE 2800:
Universal screwdriver for wood screws, drilling
screws and dry wall screws up to a diameter of
6.0 mm.
• Depth stop:
Work with and without depth stop possible.
Removal of the depth stop does not alter the set
screw insertion depth. After refitting, work can
continue at the same insertion depth.
a
6 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match your
power supply.
Scaffold hook (5) assembly: Clip into scaffold
hood mounting (4) and turn until it engages in the
desired position.

7 Use

7.1

Switching On and Off

To start the machine, press the trigger switch (2).
The speed can be changed at the trigger switch by
pressing.
For continuous operation the trigger switch can be
locked using the lock button (3). To stop the
machine, press the trigger switch again.
7.2

Selection of direction of rotation

Do not activate the rotation selector
switch (1) unless the motor has
completely stopped.
Select direction of rotation:
R = Clockwise
L = Counter-clockwise
7.3

Tool change

Inserting tool:
Hold the quick-change lock (8) firmly in position
and insert tool.
Check that the quick-change lock (8) is in its front
position. Pull on the tool. The tool must be held
securely in position by the quick-change lock (8).
Removing the tool:
(See page 3, illustration 1a)
- Remove depth stop (6).
- Pull the quick-change lock (8) to the rear as far as
the stop (which unlocks the tool) and hold in this
rear position.
- Remove the tool (7).
If the quick-change lock (8) cannot be pushed to
the rear by hand, the depth can be used to do this.
Proceed as follows (see page 3, illustration 1b):
Option 1 :
- Insert the tool in a lateral bore of the depth stop
(6).
- Use the depth stop (6) to push the quick-change
lock (8) to the stop at the rear (this locks the tool).
- Remove the tool (7).
Option 2 :
- Place the depth stop (6) on a table, for example.
- Mount the machine with the quick-change lock
(8) on the upper edge of the depth stop (6).
- Position the quick-change lock (8) on the upper
edge so that the quick-change lock (8) is pushed
to the rear when the machine is pressed down.
- Press the machine down.
- Hold the quick-change lock (8) firmly in this in
position by hand.
- Remove the tool (7).
Fit the depth stop (6) again:
turn and engage in position when mounting.
7.4

Working with depth stop

See page 3, illustration 2 a and 2 b.
To preset screw insertion depth, one of the screws
to be inserted is fitted on the tool. Set the depth
stop (6) by turning as follows:
a) Screws whose heads are to sit on the material
(socket-head screws, oval head screws, hex
ENGLISH
ENG
7