Pfannenberg 6201C Instrucciones De Servicio página 79

GB
5.2 Cleaning the cooling unit - Unit cover removal
Item Designation
1 Fastening screws
4 Bottom plate slot
Requirement
-
The cooling unit is de-energized.
-
Wait for discharging phase of 5 minutes for the electrical components. Only then open the device.
Procedure
 Remove the fastening screws (1).
 Tilt the unit cover (5) forward 20° (2).
 Disconnect the earthing cable and connecting cables from the display or operating unit (inside) (3).
 Raise the unit cover about 15 mm and pull it out of the slots in the bottom plate (4).

The unit cover is removed.
Operating Manual DTS and DTI 6201C / 6301C Multi-Controller (MC) 086100014c © Pfannenberg GmbH
1
5
Figure 22 – Unit cover removal
Item Designation
2 Tilting angle 20°
5 Unit cover
1
2
3
Item
3
4
Designation
Display or operating unit
Page 36 / 43