Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
First of all remove stray food bits and grease drops from the cooking
surface with the special scraper (Fig. 4).
Then clean with speci c products for vitroceramic cooking surfaces with
a paper towel, then rinse with water and dry with a clean cloth.
Pieces of aluminum foil and plastic material which have inadvertently
melted or sugar remains or highly sacchariferous food have to be
removed immediately from the hot cooking area with the special scraper
(Fig. 4).
Fig. 4
This is to avoid any possible damage to the surface of the top.
Under no circumstances should abrasive sponges or irritating chemical
detergents be used such as spot removers.
DO NOT USE STEAM CLEANERS.
TROUBLESHOOTING
FAULT
F0
Fc
Ft / Fe
Fb
Fu / Fj / Fa / Fc / Fd
Fr
CAUSE
Electronic error
Electronic control overheated
Electronic temperature sensor
may be damaged
Excessive key sensitivity
Touchpad error
Relay error
When one makes use of heating elements, we advise receptacles with
at bottom (Fig. 5) having same diameter or lightly higher than that of
the hot area.
NO
Fig. 5
-
Avoid over ows of liquid, therefore when boiling has happened, or in
any case when liquid is heated, reduce the heat supply.
-
Don't leave the heating elements on without receptacles on the top
or with void pots and pans.
If there is even a slight crack in the cooking surface, immediately
disconnect the power supply to avoid the possibility of electric shock.
Disconnect and reconnect the power supply. If the error persists, call after sales
If the cooking zones are switched o , wait until the temperature is lowered.
The cooking hob will start working again when the temperature returns to normal.
Wait until the temperature is lowered. If the message persists even after the value
returns to room temperature, call the after-sales support.
Check that the glass-ceramic work top has been installed properly. Call after-sales
support to make sure that keys touch the glass surface correctly.
This error is an automatic keypad check. It will disappear when the automatic check
is reset to the correct value. If the error persists, contact the after-sales support.
There may be a problem with one of the relays. Disconnect the power supply, wait
one minute and switch on again. If the error persists, call after-sales support.
– 11 –
NO
SOLUTION
support.
EN
YES
Publicidad
